Questions & Answers for: Dodge bad cam

...from the crankshaft sensor or somewhere else like that..and when you plug it in it is getting a bad reading from the cam sensor wich will cause it not to run..so my advise is your cam sensor is

...cam pickup was bad on the new cam gear and we had a no start problem. i took the valve covers back off put the old gear on the cam and it started. BUT be careful if u do that you have to wedge the ...

...be missing the teeth at the crank make sure the cams are turning, if not, replace the timing belt. if belt is o.k., check the cam sensor. if the cams dont turn or the cam sensor is bad, it wont ...

bad cam sensor, how do i feplace it... Bad cam sensor how do i feplace it On the 2.7L V6, it is on the front of the left cylinder head, just below the valve cover. One bolt holds it in position, and ...

...cam is bad then personally I would trust him and let him redo the cam. To make a long and complex answer short. If the valves dont open at the right time for the correct amount of time, bad things ...

...bad cam sensor and a couple of bad glow plugs is the cam sensor hard to change before you change anything else, Unhook the battery and wait ten minutes,,hook it back up Neg terminal first ,, maybe ...

...bad cam sensor I've had a cam shaft sensor go out every year for about three years. Read that the cam shaft end play may increase failure if it's over .013 So, is it possible that it would ...

...won't work my cam sensor won't work You had the cam sensor back probed & scoped & it tested bad? Or you just got a code Codes do not tell you what is wrong or to replace ...

...or ckp. And a p1684 and my dad put a new computer in and it show down thats the cam and crank sensors, i usually replace them both when one is bad, usual for the cam sensor to go bad on the 2.4 ...

...times should line up
if not move the cam

if engine runs and idles cant be that bad
what code it it throwing ?

clear the code each time you read the