...backup Lamp Assembly Remove the rear compartment lid trim. (if necessary) Disconnect the license/backup assembly connector from the body harness. While removing the license/backup lamp assembly from ...
...BACKUP LAMP REPLACEMENT REMOVAL PROCEDURE 1. Open the rear compartment lid. 2. Remove the rear compartment lid trim. 3. Pull back on rear compartment trim panel. 4. Disconnect the backup lamp ...
...backup lamp relay. The BCM grounds the backup lamp relay control circuit energizing the backup lamp relay. The BCM connects directly to the center console fuse block with no external wiring between ...
...backup lamp relay. The BCM grounds the backup lamp relay control circuit which energizes the backup lamp relay. 2 Install a scan tool. Turn ON the ignition, with the engine OFF. With a scan tool, ...
Question about 2001 Impala
...backup lamp request signal is sent from the powertrain control module (PCM) to the body control module (BCM) on the class 2 message system. This signal is based on the park neutral position (PNP) ...
...backup lamp assembly 2005 impala Did you check the fuse , relay ? Backup Lamps The B/U LAMP fuse in the RH I/P fuse block supplies battery positive voltage to the switch terminal of the backup lamps ...
...backup lamp request signal is sent from the powertrain control module (PCM) to the body control module (BCM) on the class 2 message system. This signal is based on the park neutral position (PNP) ...
Question about 2001 Impala
...backup lamp request signal is sent from the PCM to the BCM on the GMLAN serial data system. This signal is based on the park neutral position (PNP) switch signal. The BCM supplies voltage to the ...
Question about 2001 Impala
...backup lamp request signal is sent from the PCM to the BCM on the GMLAN serial data system. This signal is based on the park neutral position (PNP) switch signal. The BCM supplies voltage to the ...
Question about 2001 Impala
...backup lamp supply voltage circuit to the backup lamps and to the automatic day/night mirror. The backup lamps are grounded at G401. Voltage for the backup lamp supply voltage, without RPO YF7 the ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions