Questions & Answers for: Epic back view

...view 550 treadmill and she stop the treadmill at an incline of 4 OR 5. Now the incline is stuck at an angle and will not change or go back to zero. Check the motor and the gears that run the unit up ...

...plastic foot rails. Do not drop the frame to the floor. Make sure to bend your legs and keep your back straight. Dude, you are a freaking GURU!!!!! I spent forever searching online, looking for ...

...$7,000.00 units. My suggestion is unplug the treadmill then remove the upper console. Remove the back panel find the two wire that come form the fan motor get a 9v battery plug it into the motor ...

How do I remove the cover to replace the motor belt? There are 3 screws across the back of the cover and then there are 2 more screws located on the bottom side of the cover. You will need to fold the

I am trying to take the motor cover off to replace the motor belt. I have removed the screws in the back panel, but the cover still appears to be in a bind and I cannot find any other attatchments in ...

...belt is slipping. How can we fix it? hi, if the belt is slipping you need to tighten it, at the back end of the treadmill on the corners there should be two bolts turn them both untill you can ...

...and reinsert the safety key. The machine should run the full cycle, up to maximum elevation, then back down. If the motor moves and then resets, you may have an incline motor sensor defect. You

...Remove the motor drive belt. The front roller should now be removable. If you have difficulties, back off the rear roller adjustment bolts 3-4 turns further. Keep track of how many

The belt has shifted to the left, how do I move it back over? And it sounds louder than normal. Check the rear endcaps for damage. If they are OK, find the allen key that came with the treadmill (you ...

...back on since. I just replaced the motor controller board hoping that would fix it, but when I put the safety key in place, nothing happens. I'd appreciate any thoughts on the matter. Hoping I don't ...