...paper when the print head and cutter starts across it...any help would be greatly appreciated. Thanks Blue Sounds like the overdrive clutch is't working. try rolling the small rollers under the ...
...paper (18"x24") back out and then the media lights blinks ...... can you help me. Make sure your paper is aligned with the left edge of the rectanglular holes on the right side of the printer paper ...
...paper back onto the paper roll and feed the paper back into the plotter until it senses aper then it will plot that job. Next job you have to repeat previous steps. I have this problems whit Cleanout ...
Question about Designjet 5500 (42 in.) InkJet Printer
...paper and feed it in front of the black roller and in back into the printer. You really don't need to be precise, the path will accept the paper. Keep pushing the paper until it comes up the the top, ...
Question about DesignJet 430 InkJet Printer
...paper and then flip it back up it aligns then it cuts the paper strait then it will wait a minute and unspool the paper this is driving me crazy. could u plz tell me that Ready Led is also on along ...
...paper through and then guide it back so that the lead edge just barely shows up, below the small, black rollers in the main print area. Now lock it down and reboot the system. Once the print head ...
Question about Designjet 110plus nr InkJet Printer
how do you clear a paper jam on the hp designjet 110 open the back of the printer and remove paper,clean the wheels and ready to go.
back, front, and side to ensure that you see the rollers and remove any paper or debrise blocking hitched on the rollers or in the printer. You may also want to ensure that the holders on the sides of
...paper back and forth then ejects it from the tray or rejects it from the front. Printer printed the paper calibration sheet but then won't read it. It sounds like you have a bad leading edge sensor. ...
Usually answered in minutes!
125 Questions
147 Questions
140 Questions
140 Questions
87 Questions