back onto the valves. 5) Call an appliance repairperson; there may be a defective inlet valve or a problem with the controls. Auto Temp Control keeps HOT water from being HOT. It is just warm. Need to
Question about Elite 45986 Front Load Washer
...Kenmore machine. This is what done. 1. Unplug the washer 2. Take of the toe panel in the front by removing the three screws. 3. Get a bunch of towels (I mean a bunch!!!) 4. The pump is in the center, ...
...washer.Take of the toe panel in the front by removing the three screws. Get a bunch of towels (You will need a lot)The pump is in the center, and it has a plastic grip handle that one can unscrew to ...
...washer Turn off cold water valve and unscrew the cold water inlet hose off the machine. Dig the filter screen out of the valve, clean it, and re-install screen, hose, and turn water back on. If that ...
...kenmore elite he h4 washer and it flashed f 02 then stopped working it wont spin This is what done. 1. Unplug the washer 2. Take of the toe panel in the front by removing the three screws. 3. Get a ...
...Kenmore machine, this is what done: 1. Unplug the washer 2. Take of the toe panel in the front by removing the three screws. 3. Get a bunch of towels (I mean a bunch!!!) 4. The pump is in the center, ...
washer back into its working position.Plug the power cord back into the outlet and start the wash cycle again. If the FH error code comes up again, call a service repairman. If the hoses have no kinks
Question about 3.8 cu. ft. HE4t Front Load Washer
kenmore EH4t front load cloths washer. The code is F02. What does it mean? F02 is for not draining correctly. Here is what you need to do: 1. Unplug the washer 2. Take of the toe panel in the front by
Question about HE2 Plus Front Load Washer
...Kenmore h2plus washer? During wash cycle we have an F11 code. From what we have read it is telling us to check connections to the MCU, where is this located? Model #11047532602 1 Check for any error ...
Question about HE2 Plus Front Load Washer
kenmore stack washer dryer.cold water fills extremly slow,hot water fine Check the strainer at cold water inlet where hose connects to washer solenoid valve in the back. It’s most likely clogged with ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions