Questions & Answers for: Subaru axle nut

Question about 1992 Justy

1 Answer

...axle nut. Loosen the Axle nut while the car is on ground. Loosen wheel nuts. Jack up car and place jack stands underneath. Go underneath car and turn the wheel till you can see the pin through the ...

Ad

...axle halves, I run the Nut off till it is level with the shaft end. THen take a piece of wood and set it across the shaft and hit the wood with a hammer. Usually only takes one or two hits and pops ...

Ad

axle nut, remove cotter pin for ball joint followed byt the casttle nut, disconnect ball joint from nuckle and then remove axle from hub. Remove roll pin that goes through the inner joint with a punch

...axle in the drive hub,the nut may be punched or "staked"into the grove of the axle end and can usually be pushed out with a cold chisel .On the diff end of the axle there will be a large pin holding ...

...nut from axle on driver side of 1995 Subaru Legacy I took off the brake apparatus, but am unable to remove the big shiny nut. The Chilton book for Subaru 1985-1996 on page 7-10 lists a removal of a ...

Question about 1991 Legacy

1 Answer

axle nut to then get at the hub (need a flat screw driver to lever the nut tang up first). If it's seized on put the rotar and wheel back on (leave the axle nut off) and gently rock it in a top-bottom

...lose the spring washers and try support it when removing to prevent damage to the centre bearing. unbolt the axle nut raise the car in the air hit the axle head with a mallet pop them out of the ...

Question about 1991 Loyale

2 Answers

...take the outer tie rod end nut off,cv axle nut and strut bolts,swing it out,some you might have allen head bolts at the tramnsmission also,very easy job. Tim 99 front axle what and how easy to ...

...axle nut from a 2001 forester cannot remove axle nut from axle on car help????? Remove the centre from wheel but leave the wheel on the vehicle. With the vehicle on the ground,Put the vehicle in park ...

Question about 1998 Forester

1 Answer

AWD. How can I remove rear axle? Undo the outer axle nut, then undo the strut (two bolts) and fold the upright outwards. You can then get the axle put of the hub, then out of the diff.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Subaru Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Oliver Street

Level 2 Expert

73 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...