Questions & Answers for: Technics aux input

...there... 1) Turntable --> Input on Pre-Amp --> Output from Pre-amp goes to INPUT of either Line, CD, Aux, or Tape input on receiver/amp/system. Hope this helps. - OPTiC The 1200s Expert ...

...Technics Sa 200 You'll want to use the AUX, because it, for sure, does not have any RIAA equalization, which the phono input may or may not have. Short answer: Plug the mp3 player into the AUX

...aux input but the humming increases with the volume Do not connect your PC output to the Phono input, it is a mismatch. Thye output from the PC will be "line level" or the same level as tape input, ...

...to play with an Onkyo TX-SR605 Hi, If your amp has no dedicated phono input you need to use a preamp to boost the turntable signal. You can then input via cd or aux input. ...

...phone jack on your ipod and the other ends to your amplifier aux or tape input and adjust the volume to low on the ipod - select the input on the stereo - Aux or tape in. You'll need this type of ...

...switch the SC-DV290 to PHONO mode. Another way would be to purchase a "phono preamplifier" from ebay: Hook the turntable into the phono preamplifier, and the preamplifer into the SC-DV290 AUX

aux or cd inputs however the volume output from your amp will be low. A preamp will fix that. Connect from the record out plugs on the rear panel panel to the mic input on your computer. You will need

aux, tape etc) except "phono or turntable", then switch to respected input on the receiver. Be sure all volumes on both units are down during this process, then gradually turn up both volume to normal

...input jacks maybe with the video labled "Aux"? If so, you can use only the Red and White jacks leaving the Yellow(Video) unconnected. Maybe you can attach a photo of the rear of this amplifier where ...

"aux' or "line" input which is usually on the rear of the receiver. It is usually 2 RCA jacks so you'll need to get a patch cord with a 1/8" mini phone plug on one end a (2) RCA plugs on the other end