Questions & Answers for: audio amplifier 1 channel barely

audio-related setting I can find. Unfortunately nothing fixed the problem this time. I am beginning to think the sub-woofer amp or the sound card is the problem. However, before I replace the speakers

...1. THe pre-in and Out jumpers are in place. 2. The vcr seletions are off. 3. the right speaker buttons are in and out. Happens on mine a lot... someone means to hit the power switch and hits the ...

...1. Mic. You can verify if your mic is causing the motorboating by grounding pin#3 to transmit without any input audio/mic connected; with pin#3 grounded and no audio in, determine if you still have ...

...amplifier than it splits into 1 were your rca cables will plug into just that one thats how you bridge these confusing amps.... TRUST ME BOTH SUBS WILL SLAM HARD I RUN 2 JL AUDIO OFF OF MINE NO ...

...1.1000 even when I turn the gain all the way up, I can barely hear the sub. I also have a PDX 4.150 used to power my front components (Polk SRS650). I removed the PDX 1.1000 and used the rear 2 ...

1 and #2 are OK, stop. It sounds [forgive the pun] that the receiver's output MIGHT be faulty, though its very very unusual for both Stereo channels to "die" together. #4. Do you use the receiver. for

...audio doesnt work it comes on just doesnt push any sound out Hello jcrowe8, You do not say what type or how many subs you have connected to the Bolt B2.150.2, but it would be a strain for it to ...

...enough info 1). What is the impedence load of the speakers? I'm assuming you've wired three per channel. 2). Is your amp stable at 4/2/1/ or very rarely .5 ohms. Check the owners manual for the

...audio amplifier, the result would be a low-amplitude, distorted sound. If all is well with the audio amp, you will have to find the audio DAC chip. Start by downloading its datasheet and identifying ...