...Where do I find the vacuum that causes air to come from defrost only problem? The hoses are attached to the back of the selector and then run up behind dash. there are only 2 things that
cylinder head an 1 big plug on the back of ur motor inside the bellhousing that the transmission is attached to
...attach to the cover, undo any nut or bolt remove the cover, clean it of all old gasket etc, also the matching surface on the head or heads, place new gasket on the cover with some gasket cement, also ...
...could have caused a crack in the composite intake manifold 4) under torqued intake to head attachments. There are also quick disconnects for the heater hoses which may not be properly ...
... blown out the drains on each corner? Next you drop the head liner & see if the drain hoses are attached I bet they are ...
...Check the coolant overflow tank, the hoses and the metal pipes the hoses attach to. If there is bubbling in the tank after driving the you may be low on coolant or have a blown head gasket
...Discard the O-rings. Remove the intake manifold. Remove the thermostat housing bolts (1) (image 1 attached) Remove the thermostat housing with thermostat (2), from the engine (image 1 attached). ...
Question about 2000 DeVille DTS
...camshaft drive chain Electrical connector from the Engine Coolant Temperature (ECT) sensor Nut attaching the coil cassette ground wire to the cylinder head Bolt attaching the exhaust crossover ...
...to replace throttle control sensor on 2006 cadillac sts should be on side of actual throttle body attached to throttle shaft with two retaining screws either torx head,or possibly phillips head ...
...and how do I replace it? Find the upper hose on the passenger front of the engine. The part it is attached to is the thermostat housing. Remove the hose from the pipe. Remove the bolt that holds
Usually answered in minutes!
1,356 Questions
1,298 Questions
1,226 Questions
1,118 Questions
921 Questions