Question about Aqualink - Rs24 One Touch Pool / Spa Combination Control System
...2 problems: AquaLink controls out by pool are not functioning properly. When switching from automatic to service mode to time out, you hear a clicking noise; and remote isn't functioning either; the ...
Question about Aqualink - Rs24 One Touch Pool / Spa Combination Control System
Aqualink turns on randomly I have the same problem with my Aqualink control. It turns on at random times. If I switch it back it will only last for 2-5 min. change spa side switch
Question about Aqualink - Rs24 One Touch Pool / Spa Combination Control System
we are trying to install a 2 speed 3 horsepower jandy relay part #6581 for a pool pump into an aqualink control box. the instruction come with the relay ? be care full
Question about AquaLink RS2/6 All Button Dual Equipment -
Aqualink RS6. When the aux 2 (lights) button is pushed the GFCI pops. Happens if button is pushed in the house on the controller or at the power center. I have had the lights all replaced with results
Question about AquaLink RS2/6 All Button Dual Equipment -
...way up and hook up the firemans switch to pins 1 and 2 on the big plug in aqualink see inside panel of aqualink with heater all the way up aqualink will turn it on and off leave heater on all the ...
Question about Aqualink - Rs24 One Touch Pool / Spa Combination Control System
aqualink general fault message. The codes are 172 and 183. The unit is only 2 years old. Besides cleaning the sensors, any other solutions? thanks Brian [email protected] if salt salinity is ok replace
Question about Aqualink - Rs24 One Touch Pool / Spa Combination Control System
...then the screen goes blank again. The diagnostic says: 1. battery ok 2. H2O ok 3. Air: ok Solar: Opened (I dom't have a solar system) Any thoughts? replace transformer inside aqualink ...
...temp should be displayed. Whats wrong. 2. The aqualink RS one- touch will not light up anymore. What's the problem. check water temp sensor then make sure 4 pin connector is connected to PCB ...
Question about Aqualink Rs4 One Touch Control System Control System
aqualink rs4 8158 Rev JJ Aqualink is showing 2 error codes: 6700 REV C and 8158 Rev JJ. Any advice on how to fix? make sure wire isnt shorted
Question about Aqualink Rs4 One Touch Control System Control System
...it was a $40 fix. see if hooked up with 4 wire from heater to aqualink if so try checking wires for one loose or off if ok try to use the firemans swith to pins 1 and 2 then heater button will ...
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions