Questions & Answers for: antifreeze overflow line

antifreeze should be added into the overflow reservior the large plastic tank, add the coolant up to the full line, there is two plastic tank the other is for the washer fluid, make sure you add it to

...antifreeze from the overflow tank into the radiator. Then check the level line on the overflow bottle(tank) for the normal amount of antifreeze per marks on the bottle. You should have your radiator ...

...to top off there is an overflow jug that will have an indicator line on it. The antifreeze should come to the line and should be filled while the engine it hot. normally no more than 2 hope this ...

...ANTIFREEZE GOES. Not sure of your vehicle, but... If you have a radiator cap on the radiator, you can fill it there, and the coolant overflow tank should have a full line, so fill that to there. Make ...

...antifreeze container. Once the radiator is full let the car run until the thermostat opens up and you should see the level of fluid go down in the radiator. Fill the radiator again while the ...

antifreeze/water leaking . puddle underneath van already got new thermostat, radiator is full overflow box full. can't see where leak is coming from. either from below or above view is blocked by ...

...antifreeze?...radiator fluid?...if Rad fluid..look for your overflow tank, and add it there. The cap may be yellow, and may have "rad fluid only" printed on it. gas line antifreeze goes directly into ...

...overflow tank with antifreeze and started the van. I rocked the van to get air to move out of the lines and kept adding antifreeze until it was full. then used the overflow tank to top it off. Hope ...

...ANTIFREEZE IN THE OVERFLOW JUG UNTIL COOLANT LEVEL STAY THE FULL COLD MARK.WAIT AWHILE UNTIL COOLANT LEVEL STOP DROPPING.NOW INSTALL THE RADIATOR OR OVER FLOW JUG CAP.START THE ENGINE AND ALLOW IT TO ...

...overflow". This is the correct tank. If the Antifreeze is LOW you need to pressure test the Radiator and system for leaks. The Antifreeze should not get low. It means there is a problem. There is a ...