...1 cable input line with this 2nd TV experiencing this problem. The other TV picks up all the 31 channels without a cable box. Can you offer any help on this problem? First time user so I not quite ...
Question about DVR-625 DTV Receiver / 100-Hours Video Recorder
ant. connected to your 625 receiver will only work on tv 1. The only way to do this is to RF modulate your tv 2 coax to an RCA and hook the RcA cable to your tv2. then use another ant. to connect coax
...Ant 1 (Air) and Ant 2 (Cable) Hi: I used Ant 1 for a coaxial hookup to my antenna for over the air signals. When removing the TV from the wall I accidently pulled off Ant 1. Is there a way to use Ant ...
...1. you tuner is bad(not hardly) 2. the connection is bad. Ether case here you need to investigate, please do rate my solutions and click the accept button for my efforts. thanks for using fixya.com ...
...1 Find and disconnect the cable that is connected to the ANT IN terminal on your cable box. ➢ This terminal might be labeled "ANT IN", "VHF IN" or simply, "IN". 2 Connect this cable to a ...
...1) Make sure the tv's vide mode is in "TV" or "ANT" or "Antenna" some times even referred as "Off Air" 2) In the TV's settings make sure a "Channel Scan" has been performed to tell the TV which ...
Question about 42PFL5332D 42 in. LCD Television
...1. I moved and had to put the DISH receiver in another room and ran a coax cable to where the TV is now using the ANT in spot. I select TV as the source and choose channel 60 and no signal. I hooked ...
Question about DX-949 40-Channels Base CB Radio
...ant associated antennas have 50 ohm outputs and outputs. This is for a reason. Ohm's law says Maximum Power Transfer occurs when Resistance In equals Resistance Out. In order to ...
...1 channel to program on my toshiba To program i press the input button on remote repeatedly until ANT/CABLE is selected. 2. then press the menu button on the remote control using the arrow buttons, ...
...1 Turn off all of your components. This will help prevent any accidental damage while connecting. 2 Connect the RF/COAX Out port on the VCR to the RF/COAX/ANT In port on your TV. Use a coaxial cable. ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions
