Questions & Answers for: amp speaker flashes red lights

Question about KAC-859 Car Audio Amplifier

2 Answers

amp is bridged wrong, it can do this. If the load impedance is too low, it can also do this... don't trust the speaker, it it says 4-ohm, it may actually be 3.8-ohm, which could cause a problem if two

Ad

Question about GM-X542 Car Audio Amplifier

1 Answer

...need to check the power/ground wiring and fuses. If the voltage remains above 11 volts, you may have a problem with the load on the amp (incorrect ohm load, shorted speaker, shorted speaker

Ad

Question about Excelon KAC-X521 Car Audio Amplifier

1 Answer

...in any way. i rewired the whole system and it seems to go out whenever i turn up the volume. i dont know if its my speakers that are blown or my amp is messed up, check speaker and power ...

Question about Excelon KAC-X521 Car Audio Amplifier

2 Answers

...is to low or the voltage drops below 9 volts. First do you have at least 10 ga speaker wire and 2 ga power wire with an 120 amp fuse? You might need to upgrade your battery-alternator and add a ...

speaker wire connections to see if the amp will stay on. If the problem goes away when disconnecting the speaker wires try this: 1) Check volume level on zone one and zone 2 if connected. If it is too

Question about GM-5200T Car Audio Amplifier

1 Answer

...amp. Either split each 4 ohm speaker onto its own channel or switch to 8 ohm speakers. While you might check these and still have a problem, hopefully these will eliminate some sources of problems ...

Question about Bowers and Wilkins Zeppelin iPod Music Speaker System

1 Answer

...amp;W Zepplin flashes a red light all the time My B&W Zepplin flashes a red light when the IPod is connected and will not play. Without the IPod attached it will initially go green for a few ...

Question about Bowers and Wilkins Zeppelin iPod Music Speaker System

1 Answer

amp in the speaker outs, other than that your amp may be fried. By the way, if it works without any speakers connected, including RCA's try connecting one component speaker at a time starting with

...amp the red protect mode lights always on even with no speakers hooked up with speakers it sounds like a rapid popping sound in the sun and the light flashes rapidly help Bad connections or a bad ...

...amp on the left speaker pops and the red lights on the amp indicating the units connected flash consecutively and nothing works. It usually means your speaker has popped and you may have to get a new ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

5117 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Car Audio & Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...