Questions & Answers for: Soundstream amp smoking

amp staying in protection mode Brand new xta880 wont stay on - the protection circuit light comes on as soon as the amp does, then goes off and doesn't come back on until I reset the remote/head unit.

need to know average amperes need to run at moderetly loud level have two soundstream amps a pca1000d 1000wattx1 at 2 ohm I also have a pca4.400 100x4 @ 2ohm need to know minimum amperes to run both ...

no power going to the amp but power running everything else i have a soundstream amp and a power cap, there is power running to the cap and the neons but not to the amp i have check all the fuses and ...

not powering up no current tried every thing Hi apart from the + & - connections to the big terminals, the terminal marked "REM" or "REMOTE" needs 12 volts on it too to start the amp up. If no ...

...best 12" subs to with it match your total rms output at the resistance you will be running the amp at to the subs. example: if your amp puts out 300w RMS@ 4ohms, then it will produce 600w RMS@ ...

...the speaker is a 3 ohm.... is this going to be a problem.. matching this up with a 2 channel 4 ohm amp? If the speaker has a 3 ohms resistance, then yes. That is unless you wire two of them in

i have 2 Soundstream SPL 10 Car Speaker when i hook them to my amp they work fine for a short time then it throws my amp into protection the amp is a 920 watt kenwood what would be causing it to do ...

...smoking, then it needs to go to a GOOD technician. ( if one is available to you) if not then send it to soundstream. if this was not a good amp , I would advise getting rid of an amp that smoked, ...

amp is smoking the amp just started smoking send it to a GOOD tech or buy another

disc read err will not read disc. it will try to read the err comes up on the screen and ejects the disc. Looks to me you can put in a variety of disks, But to make sure it is not just a disk that was