...channel is blown. These are not the easiest units to repair. Given that this is a commercial amp, I would recommend that this unit be brought to an authorized Crown service center for repair. ...
... heeeeeeelp This in an indication that there is a problem detected in the final output stage of the amp. This amp will require service. Crown amps are not teh most straightforward designs and should ...
...clipping for real or overheating ? It may just be a fault with the indicator light circuitry itself. Make sure the input levels of the amp are matched with the output levels of whatever device is ...
i have a crown ce4000 amp. it turns on,but both the fault lights & clip lights are on.i was wondering what could be the problem & what is an estimted cost to repair this amp. I believed you got 1 or 2
...clipping the amp. If the output rating for the amp is 1000W into 4 ohms, this is approximately 500W into an 8 ohm load. Your speakers are rated for 400W. If you are running the amp at full output, ...
Question about CE1000 2-Channel Amplifier
...rolling gain up, right after connecting to speaker. Any ideas where to start? if ur output power amp is defective u will have that problem - meaning the moment u connect load across it it will go ...
Question about CE2000 2-Channel Amplifier
...the horns were splattering really bad. Fans seem to work. for some reason channel one of one of our amps started clipping. i first noticed it with the drum kit but it slowly moved to the vocals as ...
Question about CE4000 2-Channel Amplifier
amp is protected on clip mode how to fix it is it via software??? According to the service manual, there is an output failure. It's not off of the phone jack ckt. Either a short at one output or ...
...clipping or being over pushed. Can I fix this myself? If not, what might be wrong with it?Thanks for any help! With a crown amp it can be any number of things. I would recommend having a service ...
without any audio source or speakers on output attached, the Crown CH1 Amplifier (as soon as you put the on/off switch to the ON position, the CLIP light blinks a couple times and the FAULT lights ...
Usually answered in minutes!
62 Questions
68 Questions
33 Questions
21 Questions