Questions & Answers for: GMC akon new

not starting I have done a new timing chain new spark plugs new plug wires new fuel pump new fuel filter new rotor new cap idk wat else there is ould some one help i pump some gas in the carb it back ...

I have a 1997 GMC Sierra Ex-Cab, It shakes from the rear while braking, Have tried new shoes, new Drums, new Slave Cylinder, and New Shocks. Nothing Works try getting the new drums resurfaced. often ...

1987 GMC 3500 350 engine. engine stall and skipping, new plug ,new wire, new air filter, new pvc,new cap,new roter,new air line hose. still stall out when put in gear and skip when driven , need ...

steering wheel shakes at 72 MPH on my 1999 yukon. new hubs. new tires. new ujoint. newly balanced drive shaft. new shocks. new balljoints. new idler. new hubs. I would suspect tire balance or a bent ...

steering wheel shakes at 72 MPH on my 1999 yukon. new hubs. new tires. new ujoint. newly balanced drive shaft. new shocks. new balljoints. new idler. new hubs. if u can accerate past shake check for ...

99 gmc 5.7 vortex flooding all plugs very wet new icm new distributer new crank sensor new timing chain gears new wires check tps mas and all fuses good ran friday would not run suday all 4 02 sensors

not getting fuel in rail with new fuel pump not getting at fuel pressure at fuel rail so truck won't start the new fuel pump you bought is it new or second hand? is it with the correct ...

1990 GMC suburban vibration at 45 mph *Consistent Vibration at 45 MPH (accelerating/decelerating) *Also appears to be 'held back' and even downshifts on flat ground because it is being under a

i have a new clutch but my truck wont go into gear i have new slave cylinder new hydraulic line new clutch master cylinder new clutch disc and set and new trans i bled the the line for 3 days and have

My xr6 has a engine miss fire it has new leads and plugs ? Started after it stalled When you say new leads do you mean new wires? New ignition coils? Just remember misfire can be caused by more than ...