...lever. are you shure you have ALL the clutch plates?? the cable is well lubed? the pushrodbearing/adjuster may be in the middle of the clutch basket cover plate. OR you have the wrong springs ...
...on now clutch cable has 2 much play and wont engage tried adjusting to no avail Be sure you were given the correct cable, The stock cable is part number 54011. Compair the old cable to the new
...clutch lever off my bike put new one on cable has 2 much play tried adjustin to no avail ok, three different possibilities here. first, you replaced your broken lever with a lever that has the hole ...
...works what oil are you running in you tranny and have you tried adjusting the clutch cable? When you had your clutch apart what did the friction plates look like was there much meat left on
...clutch lever screw the adjuster so that the cable will come out then follow the cable down to the engine undow thw nuts holding the cable remove the cable and refit the new onw in the same routing as ...
clutch lever is properly adjusted, this is normally what happens if the gearbox oil is extremely dirty. Do and oil change then ride for 30 minutes. Then change the oil again to help flush out the dirt
...the clutch in and pit it in gear it still grabbed. if you tried the clutch dry it will grab. if you tried it with the oil in it and it grabbed, then adjust the cable. about 3 mil gap on the
...clutch or what can i do to fix the problem. my cable is already adjusted all the way out on the lever. Two stroke motors with wet clutches are notorious for sticking when left for a period. Older ...
...clutch lever travel (like 1/4"-1/2") before the clutch disengages. For right now, adjust the clutch so that there isn't any play and the adjustment all the way out. If the clutch disengages the ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions