...hood and get a bright flashlight handy (even in daylight) it will make them easier to spot. Look on top of the headlight assembly 1 st for the left/right screw(s) and then straight into the assembly ...
...was wondering if anyone new if i could do anything my self and the fuses under the hood are fine Have you looked for manual on stereo to make sure you didn't adjust/turn something off
...another bearing to look at would be the pulley bearing of the compressor or the tensioner or belt adjuster. these two bearings ( if you have them in your car) are sources of noises which are sync ...
to the same base model. The same goes when ordering your new belt. For emergency use you can get an adjustable belt. If you are fitting your own belt there is normally a slide mechanisim on one of the
...hood; this is a prudent measure anyway as a bad fuse can cause problems elsewhere. Once you have checked the fuses and confirmed that all are good, you may have to have your radio reset. Most newer ...
...you will see a 10 mm bolt right in the middle of the headlight assembly. This is for headlight
...'play'' in it which causes a metal on metal rattle when going over bumps. Am told that it cannot be adjusted and would have to be replaced to solve problem. Is that correct? yes that sounds right to ...
...hood its right there, but im confused as to where the belt tensionner is so i can remove it. There should be a tensioner pulley with a square hole in it that a socket wrench will fit into. Using the ...
...the hood? There is no need for power to open the hood. Your cable may be streached, or in need of adjustment. Have someone push down and up on hood itself while pulling the hood release
My 2015 Nissan Altima hood will not lock You can adjust the latch some. Raise it up. Springs do break in them also. Being 2015, most likely not the case here.
Usually answered in minutes!
1,587 Questions
1,450 Questions
1,306 Questions
569 Questions
534 Questions