adjust navigator suction How do I get the reading above 5 for my navigator hi 1st make sure the navigator is clean and wheel is free to trun also at the filter u might have a handle that controls the ...
Hayward Navigator Moves very slow I have checked the suction, installed new pods, cleaned filters and adjusted the suction at the filter. Navigator is moving incredibly slow. What else could be the ...
Question about Navigator Pool Cleaner
...hayward pool cleaner and I was left the old when when I bought my home. I do not recognize 3 parts that were in the new one. The flow gauge , the regulator valve and the cone adapter. What are these ...
...Hayward pool cleaner. First, check for improper water flow (which can be adjusted with the flow gauge that comes with your cleaner). Partial blockage of the navigator throat can also cause both of ...
...My next suggestion would be to check your water flow. Make sure that it is strong enough and adjust the water flow gauge if
...waterflow gauge and adjust it if necessary. See step 6 in the owners manual below if you are not sure how to adjust your water flow. ...
adjust the rear tension flap on the pool sweep on a hayward 925 Below is the instruction manual for these pool cleaners. There are diagrams and detailed instructions included in the manual. You should
...navigator You adjust at the wall the skimmer or at the equipment depending on your system. You will open the main suction all the way then close it down till the pump just starts cavitation and then ...
Hayward Navigator fails to get out of corners and climbs straight up a wall and remains in this positon. I have adjusted the suction flow to no avail. Check your shoes and wings to make sure that they
adjust the flow by closing off the other valves slowly until proper flow is reached. This is where the flow meter is used. If there are no valves and the Navigator is moving too fast, an in-line valve
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions