...door lock, but I'm not sure how to fix either or both. Any ideas? You most likely need to make a small adjustment to the door. While the door is open push the bottom of the door towards the machine ...
Question about GLTF1670A Front Load Washer
...door is held in it starts again. I assume that the lock switch is out of adjustment and I can hear it clicking when the washer is turned off and the door is pressed inward. First try some WD40 on the ...
...door lock, if I apply pressure to the door while washing it goes through the whole wash cycle. We have already replaced the door latch and main brain about six months ago. Do I need to hire a lady ...
Question about Affinity ATF7000E Front Load Washer
...door lock/safety switch this wax motor heats up when 120vac is applied by the washer controller during spin cycles. As this wax motor heats up it acts much like a automotive engine coolant thermostat ...
...adjust control knob from "Normal" cycle. Beeps three times, flashes ERR and PAU and, alternately 47 - which may either be an error code or the cycle time. Can't run diagnostics or self test. I have ...
Question about GLTF2940ES Front Load Washer
...thumble wash and if it wont then we should check the timer switch,motor,and the water level controler.so please call the engineer. Your door isn't properly closed - adjust the load and close the ...
Question about ATF6700FS Front Load Washer
door lock' light flashes, except when it first starts Thanks for choosing FixYa and welcome. You could have a bad lid switch. It can cause the washer to not spin. Sometimes they may just need adjusted
...adjust it so it hangs correctly? Frigidaire washer door sagging so strike and door lock not lining up correctly. After a period of time front load washer doors tend to start to drop below normal ...
Question about Affinity FAFS4272L 4.2 Cu. Ft. Front Load Washer Featuring Ready Steam with Vibration
frontdoor is closed but washer control says it is not closed frontdoor locking mechanism bent and not locked properly,take off door and bend/adjust mech so that it locks in position when closed.
Question about Affinity FAFS4272L 4.2 Cu. Ft. Front Load Washer Featuring Ready Steam with Vibration
...lock Door will not lock. Diagnostics either don't work or don't register a problem. Machine thinks it's in a wash cycle and waiting for the door to lock. I have already ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions
