...put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two adjusters down. Only screw these in until they LIGHTLY seat. Now turn each adjuster one and one
...put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two adjusters down. Only screw these in until they LIGHTLY seat. Now turn each adjuster one and one
...put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two adjusters down. Only screw these in until they LIGHTLY seat. Now turn each adjuster one and one
...put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two adjusters down. Only screw these in until they LIGHTLY seat. Now turn each adjuster one and one
...carbs will l have to adjust the pilot screw or sync the carbs --- is that going to happen by cleaning or replacing parts such as needle jet, needle valve, and carb jets? Syncing the carbs does not ...
...adjust the idle speed manually, it still drops sounds like it has low compression or that there is something blocking fuel from reaching the carbs try a new in line fuel filter if that doesnt fix it ...
adjust these your floats/ float are sticking, and letting the carbs flood, remove carbs clean them and retest here is a link on rejetting but the work is the same for cleaning.. http://www.raptorforum
...about 1000 rpm but it still hangs up around 4000rpm then returns to an idle .Can floats be out of adjustment or heavy? EITHER YOU NEED TO CLEAN THE CARBS AGAIN OR POSSIBLE VACUUM LEAK sounds like ...
spuddering on 1st gear when taking off carb needs cleaning or adjusting
how can i get my 2001 yzf r6 more horsepower and torque? Just get it tune-up to top spec, use synthetic oil, racing clutch pack and then adjust the carb a little more on the rich side. Good?
Usually answered in minutes!
288 Questions
145 Questions
115 Questions
98 Questions
99 Questions
