Questions & Answers for: Troy how do i adjust the carbs

...and clean it you would need to get new gaskets and maybe that will do the job. You may be able to adjust the carb. There is a "hi" and "low" setting. Try adjusting the ...

carbs And by the way is there a adjusting tool out there that might work better than a ground down 3/16 nut driver for it has limited sp'' that adjustment is a cap the real screw is under that cap/1/4

...through the carb with a kit and cleaned it put a new coil on it and new spark plug. The carb womt adjust out for high speed. SORRY but you didnt clean that carb good enough,if it will not adjust. ...

...ADJUST CARB Most carbs have the adjustment removed (EPA) but if yours still has the adjusting screws here are the seat of the pants methods: One Screw Carb: Turn it all the way in and then back out ...

...between choke and run In this mode, you are keeping the fuel mixture richened. You may only need to adjust the carburetor (if you can) to get the machine to run right. Older Troys had splined carb ...

...adjust the L screw (one closest to the engine) on the carb OUT 1/8 to 1/4 of a turn. Unconventional heads on thes carbs require special tools or a little ingenuity to get ahold of them. You may need ...

I have a 2 cycle Troy-Bilt TB90BC line trimmer. Won't idle. I've had the carburetor dipped, installed a new carb kit, replace the gas lines, but will only run at full speeds. Dies out easily. ...

Starts and idles ok.stalls when throttle is squeezed You might want to adjust the high side of the carb. but before doing that turn the high side jet to the right and count the turns so if it make no ...

...the exaust port, checked the fuel lines, cleaned the air filter, greased he mechanical head, adjusted the throttle screw. and it still won't idle on it's own, i'm running out of things to do

I have a Troy Bilt trimmer model TB675EC...4 cycle engine. Problem that has arisen is that it dies at high speed and under load. Starts up and runs at idle well. Have replaced new carb, fuel lines, ...