...adjust the idle on a 2009 yamaha vstar 950? Hi, Dscotty02 you need to make sure you have no intake leaks by spraying some Brake Kleen, Contact Cleaner, Starting Fluid etc. around the intake manifold ...
adjust the air fuel mixture bolt 1/4 turn at a time and let the engine settle for about 10 seconds, clockwise for a leaner mixture and counterclockwise for a richer mixture you are seeking the highest
adjust the air fuel mixture bolt 1/4 turn at a time and let the engine settle for about 10 seconds, clockwise for a leaner mixture and counterclockwise for a richer mixture you are seeking the highest
adjust air fuel mixture Hi, Anonymous the carburetor throttle shaft wheel has two cables the cable closest to the right side of the bike is the throttle cable and the one closest to the left side is ...
Question about Yamaha Big Bear Yfm350fw Air Filter
...leaned out because ur filter was cloged up ...making it run rich so was adjusted by screwing air screw out, now uv cleaned it, adjust it to make mixture richer by screwing back in until runs ...
Question about Yamaha Big Bear Yfm350fw Air Filter
...adjust the air fuel mixture screw...take it in slowly to the end taking care not to tight it toomuch to avoid damaging the tip of the screw and than go anti clock wise two and half turns to ...
adjust the air fuel mixture bolt 1/4 turn at a time and let the engine settle for about 10 seconds, clockwise for a leaner mixture and counterclockwise for a richer mixture you are seeking the highest
Question about Yamaha Big Bear Yfm350fw Air Filter
...Big Bear 350cc atv http://www.partzilla.com/parts/search/Yamaha/ATV/1998/BIG+BEAR+4WD+-+YFM350FWBKC/CARBURETOR/parts.html this page shows the carb all pieces including air mixture pilot and main ...
Question about Yamaha Big Bear Yfm350fw Air Filter
fuel pipe and the air one were clocked up, ... a lean mixture with what little gas was left in the carb and then finally ... adjustable screws etc. clean them withgas, CRC and compressed air. ... 1984
Question about 2005 Big Bear 400 4x4
Yamaha Big Bear 400 is running rich, it runs good at high speed but loads up at idle. Not sure where the mixture screw is located on the carburetor? It's a Mikuni BSR33. Question edited for clarity ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions