Questions & Answers for: Pontiac ac module

Looking To Recharge The AC in a 2002 Pontiac Montana I want to recharge the AC on a 2002 Pontiac Montana, but the owners manual does not document where the low pressure connection is for the AC A see ...

Ad

...AC erratic "Electrical module" replaced in '02. 2 ABS sensors w/in next year. Battery in '03. Battery leaked in '06 & replaced it and pos battery cable. W/in last 6 months Max position of A/C stopped ...

Ad

...before it goes to the starter? blower motor resistor bad causing one speed for ac.the clicking sound you hear in dash is the bcm module.that is the causing car not to start. dealership have to fix

Question about 1997 Bonneville

1 Answer

...AC and no Blower. I checked power connector at the blower motor and is reading 1.5 Volts. you need new blower module located at blower under hood, against the firewall under the relays it has four or ...

...ac replaced blower motor + control module and blower still runs on high will not shut off can't locate where resistor is, fuses + relays are good You replaced the blower control module or the blower ...

ac/ heater they both wont work not even defrost it use to work only on selection number 5 now it dont work at all we just put a new blower in it today and it still wont come on next to the blower ther

Question about 2005 Montana SV6

1 Answer

...Rotate the Mode knob fully counterclockwise. Release the AC button. Wait 40 seconds for the HVAC control module to self-calibrate. Start the vehicle. Verify that no DTCs have set as current

...fan has no power at plug check all fuses under hood on firewall can you tell me were I can look thanks You may need to get a blower control module. It's in the heater/ac case close to the blower ...

1998 pontiac Bonneville ac blowing out the defrost only ac programer is fine and i have the electronic climate control module theirs a vacume control module under passenger side airbag that goes out

...ac keeps running after the car is shut off The most likely problem is the blower motor resistor/module is stuck on high speed. The high speed relay is fed power all the time. If it sticks the blower ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Pontiac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...