Questions & Answers for: ac 45 Computers & Internet

...twelve oz. can in an the pressure gauge read 45 and was in the red. the car was running with the ac on high. am i doing something wrong? Is the clutch turning on the compressor when the gauge reads ...

...ac only works below 45 mph blows hot at higher our 1998 ford ranger ac only works on max and all the way cold and when the truck exceeds 45 mph it blows very hot air until you slow down any ...

AC was ON. But when I switched it off and ON again, the Fan is still not spinning. What could be wrong? Thanks, You have bad cccccccccapacitor in your outside unit. Not hard to replace but you need to

is too low on freon. Turn ac to off and fan switch to on...wait 45 minutes and try again by setting thermostat no lower than 72. While waiting the 45 minutes check the filter , blower, and indoor coil

...in degree mode Press [AC/ON]. Press [SHIFT] [MENU] Press [v] [v] [v] [v] [F1] Press [EXIT] [AC/ON]Try out: [SIN] 45 [EXE], result should be 0.5. sin 30 degrees is .5, sin 45 degrees is (sqrt ...

...45. CHECK THE AC AND HEATER CONTROL FUSE.MORE LIKELY FUSE BLOWED BECAUSE AC COMPRESSOR COULD HAVE FAILED IF LOW SIDE IS OVER 100 PSI. THE REED VALVE PLATE IN COMPRESSOR PROBABLY DAMAGED CAUSED ...

...to find spec for unit? you need a 5/45 x 370 volt mfd capacitor. I just installed one in the same type of AC today. 5 mfd is for the fan moter and 45 mfd is for the compressor, the 370 is the

Hi i am looking for part nmber of ic for altec lansing acs 45,amplifier stage. What is the part nmber of the IC for altec lansing acs 45,amplifier stage. If you wish to get some details; check the ...

...ac will not cool ,, note that at cold condition the comp. will engage normally At 45 F that is just 12f above freezing and it is possible that the thermostat inside the car is turning the compressor ...

...AC unit (compressor) with data plate that reads: min. supply circuit amp of 38 min fuse / breaker size of 45 max fuse / breaker size of 60 amps. It has a service panel with 60 amp fuses, with #8 wire ...