Questions & Answers for: Canon MultiPASS absorber is full

...says "waste ink near full". Any suggestions? thank you. You need to have the waste ink absorbers replaced, the cost of the absorbers should be around $20.00 and service is usually around ...

waste ink near full message I called canon and was told it was a $70 job to replace the ewaste ink tank. any way I can do it myself? Take paper towels and absorb the excess ink. Make sure that the ...

...absorber full I have a plain old canon i350 - cannot get it to operate says waste ink absorber full Hi..... This printer has an ink absorber that takes in ink during the printing and print head ...

...full how do I perform this maintenance? You have to remove the entire printer engine and replace the ink absorber pad, you have to s, After that you have to go into diagnostic mode to reset the ink ...

...absorber is full.Contact the service center for replacement of the waste ink absorber. bassically your printer has come to the end of its life, you can either buy a new printer or contact the service ...

...full keeps flashing It means you need a fresh ink absorber, the whole set is about $10.00 but it's best done at a shop where they can reset the counter after replacement. The ink absorbers are under ...

...absorber is full. Canon recommends having the printer serviced before the absorber becomes full. "We are aware that there are many "do-it-yourself" Web sites that offer instructions for making this ...

...absorber. Do not displace the absorbers. Or you can replace the ink absorbers at this point if you do not want to pad them dry. Then Proceed to the Waste Tank Reset procedure below: To reset waste ...

...absorber may be full, may not. But the message comes up on cannon printers after so many hours of use regardless. Just reset it. STEP 1:- Disconnect printer from AC power STEP 2:- Press and HOLD the ...

absorber full Canon pixma mp500 gave a warning that the waste ink tank absorber was almost full, but I could still print. Yesterday, it gave the error Waste tank ink absorber full, and would not print