Questions & Answers for: GMC Yukon Denali abs module

Question about 2002 Yukon Denali

1 Answer

...ABS module for the trouble code that is stored whenever this light is set to on. The most common problem is dirty wheel speed sensors, but there are 4 of them and once again you have to guess without ...

Ad

...abs unit faulty.not safe to drive vechicle.let dealership fix it.they have to use diagnostic equipment to find problem and fix it. Its the electronic brake control module( it cost about 1100 ) at ...

Ad

...ABS Module. Apparently the transistor is burnt out in your ABS module and that does cause the motor to run. All you can do for now is unplug the motor from the ABS module and order another ABS module ...

Question about 2001 Yukon Denali

2 Answers

...ABS module to find out which sensor is giving you the problem.Hope this helps.Good luck. you should have your brakes checked it could be a brake warren out and grabbing to much , if brakes look OK ...

Question about 2002 Yukon Denali

1 Answer

...kits, ABS pump module.any part that has brake fluid in it. if you know that the wrong fluid has be put into the brake fluid .you may want to check with your car insurance company it may be covered

Question about 2003 Yukon Denali

1 Answer

...HUBS, check the ABS sesors and wiring from them., A fault here can cause this error and is most common. Next check on the working of the ABS main module which might need a check at the service

Question about 2003 Yukon Denali

1 Answer

...ABS - antilock brake control module also the PCM - engine computer . service engine light DTC'S - diagnostic trouble codes stored . Your best bet , take it to a qualified repair shop or the dealer . ...

Question about 2003 Yukon Denali

1 Answer

...causes traction active error Traction control is working hand in hand with your abs brake system, possible wheel speed sensors, wiring open or short, faulty abs pump unit, eletronic control

Question about 2005 Yukon Denali

1 Answer

...AND LIGHT IS STILL ON. U1054 is no communication with Rear HVAC control module and is not connected to the Trac Off lt. Need to have truck scanned and look at ABS and PCM for codes and go from

...brakes when I try to drive sounds like the abs control module connected to the brake booster/ reservoir has malfunctioned or worn out. my advice is to take it to a mechanic and have him check it

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...