Questions & Answers for: abs jumper

Ad

ABS sensor bad. Replaced it and a few weeks later lights still on? Replaced breaks all around to include drums and rotors and both front calipers. Disconnected batt. for 10 min. nothing the lights are

Ad

Question about 1991 Legend

1 Answer

...you will need to remove the jumper, and pull all 3 abs fuses. Wait 3 seconds a reinstall the fuses. Now plug the connector back into its holder. Now start the car, and the code should be

Ad

abs light,trac light, service light on in my 2002 cavilier, what might be the reason? Jumper harness? Most likely a bad wheel speed sensor but you will need to have the vehicle scanned for which abs ...

...ABS control. A common fail point of the 2005 Equinox is the wire harness jumper for the drivers front wheel sensor. This is a foot and a half long jumper that connects the wheel sensor to the engine ...

...you can either jumper the solenoid and pump relays while pressure bleeding (you'll need wiring schematic) or SAFELY engage ABS on a slippery road surface and then rebleed the entire system

...jumper something to make the ABS light flash and get the codes that way.  Or use a professional scanner if there is an access port for the data.If the scanner says "no data" or "no connection" ...

Question about 1995 Accord

1 Answer

...ABS has its own diagnostic jumper plug did you jumper it and see if there are any DTC error codes, flashing out.? the FSM page 19-68-70 see those flow charts, did you follow it? did you see the list ...

...JUMPER AND THE DASH LIGHT SAY ABS Some dead batteries wont hold charge after completly dieing, before jumping again clean your batter connections, if this doesnt work you will have to replace ...

ABS light should flash two times per second. Switch off the ignition. Remove the jumper wire. Hope that works. If problem persists, contact a service personnel. Are you sure it's the ABS light and not

...on one of the wheels. they can be tested with a meter. resetting abs requires a reset tool. some cars can be reset after repair by using a jumper on the obdii doiagnostic comnector. google

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

john h

Level 3 Expert

23899 Answers

Brad Brown

Level 3 Expert

18666 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6647 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...