mico only heats 4 to 6 minutes My GE microwave oven model JES1142SJ will heat for about 4 to 6 minutes and then needs to cool off before it will heat again the top is very hot. I'm handy and can ...
Dryer will not fire dryer tumbles and goes through cycle ok, but will not fire, igniter comes on for short time but never fires the gas, gas supply is good, flame sensor is good, thermal fuse is good,
Question about RGX4634KQ Gas Dryer
Termal overtemp LED light on, welder not working, not overheated Lincoln welder model Invertec V160-S machine lites up but the thermal overtemp LED light is on, the welder is not overheated ...
My au Falcon teperature light comes on about a minute after the engine is started, the temperature gauge shows low temperature, the radiator is not boiling, I have taken the temperature sender unit ...
I FIND THE ERROR 010-320 WE CAN'T USE THE COPIER, BUT MACHINE IS WORKING That's a fuser overtemp fault, meaning your fuser either has a peice of paper jammed up in the fuser or the thermistor is blown
engine overtemp overtemp indicator came on ,put in garage to look at and went off overnite without doing any thig to it. Now its back again???? check coolant level
overtemp 'overtemp' code on the readout. What is the likely issue? The cooling fan is probably not working. Unit will overheat. Check the fan to see if it run continuously with no scraping noise with ...
Question about SG14 Deep Fryer
WHEN FRYER HEATS UP THEN IS LOADED TEMP SEEMS TO FALL AND HAS TO BE RESET If you manually reset by pressing overtemp thermostat, then check your operating thermostat.. maybe over heating.. if so ...
a61tt2 manual M/B hp a61tt2 mb cabinate nodel no. found
Question about HD20 DLP Projector
I have an Optoma HD20 and when I turn it on the overtemp light goes on within 2 or 3 seconds....any idea's ??? When I power it up the overtemp LED comes on in a couple seconds....I never hear any fans
Usually answered in minutes!
2,517 Questions
1,056 Questions
713 Questions
416 Questions
354 Questions