97 Jeep Cherokee Headlights and high beams are not working. Parking lights work fine, all the fuses are good. Any suggestions? try replacing both headlights. sometimes if one goes they both wont work
...97 cherokee, lowbeam headlight won't go on, I'm stumped i replaced the bulb, but still only the highbeam goes on, Should i replace the socket? Try putting your tilt steering wheel all the way up and ...
...high beams. I got a new switch from dealer and all is working great now. Here's a link a link I used for switch replacement instructions. ...
97 Jeep Grand Cherokee lights won't work high 97 Jeep Grand Cherokee lights won't work high beams work, but low beams won't. Dimmer switch is acting up. Already replaced the bulbs check fuses ...
97 Jeep Grand Cherokee low beams will not work, high beams do. We replaced the bulbs and they worked for a while then went out again. Husband took out the lights and then put them back in and they ...
97 Jeep Grand Cherokee V8 Low beams will now work, high beams do. We replaced the bulbs and the low beams worked for a while and then didn't again, husband took out passenger side bulb and put it ...
Question about 1996 Grand Cherokee
...jeep cherokee headlamps turn off and on on 5 second intervals. what could be the solution the high beams are fine. It's just the low beams thtat turn off and on in 5 sec intervals. I'm ...
97 jeep wrangler low beams dim high beams ok whats wrong Probably a bad wiring harness to the lights or a bad ground, but keep in mind jeep headlights are not known to be very bright at all.
Question about 1997 Wrangler
97 Jeep Wrangler 4 cyl. Turn signals, headlights, parking lights, tail and brake lights, and instrument panel are all out. Only interior light above brake pedal is working. Engine will start. i think ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions