poor performance at hi revs on poulan 3314 poulan 3314 4 weeks old starts great idles fine, problem is when im on full throtle and cutting it will die and and splutter and miss and then stop. when it ...
Question about Poulan/Weed Eater No. Bvm200le 711482 24cc Gas Blower/Vac
rev the trigger to cut anything, and had to restart a million times. I was determined, but annoyed. i can fix it, i know it. HELP check the fuel mixture screws on carb high should be turned in & 1
Question about Poulan/Weed Eater No. Bvm200le 711482 24cc Gas Blower/Vac
25cc poulan leaf blower runs but will not rev . it has to build up to a higher but no balls rpm It may be old gas not allowing it to rev up. or the carburetor diaphragm may need replacing. I would say
Question about Poulan/Weed Eater No. Bvm200le 711482 24cc Gas Blower/Vac
rev the engine bit by bit till it warms up, you will find the revs increase with gas to a point but if you give it any more gas it will start to stall and cut out, you have to wait for it to warm up -
...1/4 turn, rev the saw, it should pick up smoothly, if not increase the L screw another bit turn until it revs smoothly, now set the idle screw so it runs 3000 rpm approx, the H screw is the govenor, ...
I need to tune up my saw but I can't find my owner's manual. It won't idle. Need to know how to adjust the low speed. It runs well but my low speed idle won't adjust to make it keep running. The ...
rev..It runs only seconds when choke is pushed in It is sounds like it is running too lean ( fuel starvation ) before doing anything else replace the fuel filter in the fuel tank, check the fuel hoses
Question about 14" Chainsaw
I have a poulan 42'' cut riding mower that revs up good but as soon as i put the blades down to cut the engine almost drops to an idle & the mower will barely move. Lift up the blade engin
...rev up and dies. Seems like it runs out of fuel, loses prime. Loosened the cap no help. Spark is weak, but cylinder appears dry. Probably the metering diaphragm, or the low side of the carb needs ...
Question about 17" T&E Gas Trimmer
why does my poulan 2075 runs with choke on but not when i push the choke in? Crank seals could be leaking air in,or carb settings incorrect.screw both mixture screws right in,then out 1.5 turns..set ...
Usually answered in minutes!
583 Questions
457 Questions
255 Questions