Questions & Answers for: 50 fuse band

No voltage feeding the convergence ic's. the B= feeding the convergance ic's will have a fuseable resistor or a "pico" fuse, ( looks like a small resistor but no color bands). try looking for one of ...

...50% humidity with any regularity. The paper is stored flat in a drawer still in the wrapping paper. Please advise. Sounds like it's not the paper. It could be a feed path problem (the path the paper ...

...250 to $300. If you do it yourself IC's and resistors or fuse would run around $50 to $70 bucks . Don't by the $9.95 IC's as they do not hold up as well . They should cost $20 to $25 apiece . Good ...

...or possible caps that buldge at the top of them by the flyback transformer . They were 100uf @ 250v caps . All of this could be tested with a volt-ohm meter and set should be unplugged . If your ...

fuse. I seen somewhere that there is a reverse polarity protection diode on these radios. Where is it and what is it marked? When you open up the radio and look at the component side (top of pc board)

...fuse, we even changed the brake circuit boards... nothing. What else could it be? You can look into the tail light assembly through the small holes in the inside at the medal bands to look for ...

...to buy a convergence kit to repair it ur self.The shop will cost U $300-$350 for parts and

50 KVAC, since the voltage spikes easily exceed 30 KVAC. Last weekend I was wakened by a thunderclap that sounded like a cannon was fired just outside my window. Later when I got up I started noticing

...fuse size. Once you have found this value, multiply it by 1.25. This means a 10 amp radio will be 12.5 amps. A 30 amp radio becomes 37.5 amps. A 60 amp radio becomes 75 amps - and so on. This is ...

...fuse 1999 rodeo, (in usa it has obd2 level PCM and is super easy to scan and see if there are P03xx codes. did you>?) no engine stated, and is an engine question..... SSDD. 2.2L or 3.2L? both are ...