...50 is a fuser unit fault code. You can take apart the fuser unit and see if the fuser lamp is functional. Also check some of the other thermal parts on the fuser. If everything checks out, you will ...
...1522nf . I get the message " 50.2 Fuser error, Turn off and Then on"I do it but print is not good. 1/4 to 3/4 is bad print. Print is not strong and can be errased by rubbing with finger. ...
Question about LaserJet 2840 All-In-One Printer
...50.1 Fuser is hot. What is a fuser? My hp laser jet 3500 is showing an error message in the dispaly window. It says "50.1 Fuser Error. Fuser is hot. Press both sides of fuser to ensure it is fully ...
50 FUSER ERROR, CYCLE POWER, turn the printer off for 15 minutes. This allows the capacitor that is responsible for signaling this error to discharge. If you don't wait 15 minutes you will continue to
...50 Service error is a fuser error. Turn the printer off for 5 to 10 minutes, then turn it back on. If the error is still there, I think your going to need to make a service call you can try reseating ...
Fuser 50.1 error on HP 3500 printer 50.1 fuser error message showing on HP 3500 laser printer. Fuser is not hot. Took fuser out, returned it and made sure it was seated. Changed power cord. ...
...You can visit the website shown on the below link. Just visit on the link you will found the solution there. Visit
...50. To replace the fuser just open the door on the back of the printer, inside you will see the fuser, unscrew the 2 screws and pull the old one out. Insert the new fuser and screw it down, power on ...
...fuser 50 1 fuser error Yes they will Steps to Fix HP LaserJet CM3530 50.8 Fuser Error are as given below: Step 1: The first steps is to turn on the printer device. As a matter of fact, there may be ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions
