Questions & Answers for: HP 50 60 hertz

...50-60 Hz and output is 18.5V 3.5A. The new input is 100-240V 2.4A 50-60 Hz and output is 18.5V 4.9A. The negative and positives are all the same and stuff. it hardly matters if u are using a 90 watt ...

...50 sheets Minimum size envelopes 76 by 127 mm (3 by 5 in) 60 to 90 g/m2 (16 to 24 lb bond) 10 sheets Maximum size envelopes 216 by 356 mm (8.5 by 14 in) 60 to 90 g/m2 (16 to 24 lb bond) 10 sheets ...

...have set the screen-resolution to some value, e.g., 1920*1280, that the monitor does not support. Reset the screen-resolution to 800-by-600, at 60 Hertz, and see if your monitor works at that

...keeps popping up. it is trying to lower the volume every few seconds. check your screen refresh rate setting on 60 Hertz (Ctrl panel\display\setting\advance\monitor). or the OSD board was

Input frequency 50 to 60 Hertz (Hz) (+/- 3 Hz) Power consumption (maximum) 4 watts maximum when off 4 watts minimum when idle 45 watts maximum average printing (Printer carries the ENERGY STAR emblem

...60 Hertz. Connect the monitor, and see if it works at this "low" resolution. If it does, try 1024 by 768, then try 1280 by 1024, then try the "native" resolution: 1680 by 1050, to see if it works at ...

...Refresh Rate [Set to 60 Hertz]. (This usually happened if you switched monitors, or used a TV, or maybe a projector). You can use the same method to set up any resolution or refresh rate you

...Refresh Rate [Set to 60 Hertz]. (This usually happened if you switched monitors, or used a TV, or maybe a projector). You can use the same method to set up any resolution or refresh rate you

50, C-60, or Z-01 1.00 GHz processor. After you insert the HP printer software installation CD or run the driver installation downloaded from the HP website, the setup does not open. You might receive

...I NEED IS MADE BY SHANGHAI DONGRONG CBB61 IT IS A 15uF, 300VAC 50/60 HERTZ You can use any capacitor that will fit as long as the microfarad is the same and the voltage is at least 300Vac or