Questions & Answers for: 4 wheel dr problems

...wheel dr the front drive shaft turns but the front wheels wont, what could this be? if you look there is probably only one axle shaft turning also that shaft should not turn unless the wheels are ...

wheel dr. (4Hi) the noise goes away, although you can still hear a hum like driving over a rough road. Do you know what this could be? Check drive shaft bearings , may be worn or broken. Good luck and

...wheel dr. low but not like it should. Somtimes when I push the buttons to transfer from 2 wheel dr. into 4 wheel high and low, it takes some time to transfer. The forward works real good and ...

wheel dr, 5 lug wheels; I want to lift 2-3 inchs...no lift kits seem to be available. Dave It would be best to only do a body lift kit if driving on the road.Suspension lift kits lead to a lot of tire

...pulls to the right how do i fix this The right wheel shaft may have slipped its pin, allowing the left wheel to provide more power. I had a similar problem with a DR Mower. Farmerbear at ...

4 wheel drive clicksig in right wheel, does not go into 4 wh dr Do You Have locking hubs on front axle, If so, That is probly where the problem lies. Good Luck

...dr swith There are a few things that would cause this problem.The first and most common would be the switch itself is bad. the next would be a bad 4wheel drive encoder motor, this is the motor on the ...

...wheel dr. Vehicle must be warmed up for 15 minutes before 4wheel dr. Engages. Summertime driving was no problem.no excessive when it does engage . Poss. Torque converter? Torque Converter has to do ...

...wheel dr iiivei If the steering wheel moves back and forth at 15-20MPH, the tires most likely have a slipped belt. The only way to diagnose which one is bad is to get a full size spare and put it in ...

...tacoma standard 4x4 is stuck in low axle 4 wheel dr. What is the problem? if it is a knob operation to change range , then check for vacuum hose missing of range actuator , actuator or linkage ...