...amplifier stopped working on one channel,so what he did is openened the amp,tested the mosfet transistors and it showed signs of failure.then he went shopping for same type of mosfet transistors and ...
Question about C150 Car Audio Amplifier
boss chaos 150 200 watt that shows light but doesn't produce sound i have a boss 150 dual channel 200 watt amp in bridged mode that will come on and display the green light but will not produce sound.
help BOUGHT A RENEGADE AMP 4 CHANNEL WORKING FINE FOR THE PAST 4 MONTHS NOW ONE SIDE OF THE AMP IS DEAD WHAT CAN THIS BE CHECKED THE FUSES AND ALL SEEMS OK I recommend you swap your left and right ...
Question about CHAOS CH450 Car Audio Amplifier
...and was working properly. It sounds like the output is shorted. The CH450 may be operated as a 2-channel amp or both channels can be bridged for mono powering subs at an impedance of 4ohms or
AMP STOPPED WORKING. PROTECTION LGHT KICKS ON AT STARTUP & POWER LIGHT KICKS OUT your ohm load is to low. tell me what kind of subs you have and what size, and what size amp do you have? and how ...
This amplifies with little profit and is very hot, this happened after he burned two mosfet on one channel, the numbers are IRF3205. these were changed and after that the problems get started. All ...
Question about gt580 - GT580 1000W 2 Channel MOSFET Bridgeable Power Amplifier Car Audio Amplifier
...channel 3000 wt amp 1400x1 for sub and 400x4 for other speakers i cant get sub to come on i have power to amp fuses are good Check the power pack and the fuse to make sure the are working but if the ...
Question about Blade BL700 2-Channel Amp - 300W Blade Series 700W Maximum Bridged Mono Remote Level Control Car Audio Amplifier
...channel of the amplifier and the other voice coil to the other channel of the amplifier. If it is a DVC 2OHM you can also connect it wired in Series/Series to give a 4OHM load and should be connected ...
Question about AUDIO RT-645 2-Channel Riot Series Amplifier Car Audio Amplifier
i have a boss rt645 2ch 1400 watt amp would this amp properly push a pair of 12 inch mtx terminators. That all depends on the wattage of the subs. also the independance of the subs. If your amp is ...
can i fix a blown channel If you have proper tools and electronics knowledge then sure you can. Probably it will require you to find the faulty amp IC (or mosfet) and changing it by a new one of exact
Usually answered in minutes!
33 Questions
18 Questions
25 Questions
1 Questions