Questions & Answers for: Suzuki GSF 1200 Bandit S 30 amp fuse blows

Question about 1997 GSF 1200 Bandit S

1 Answer

i have 1200 bandit 2001 that smokes blowes out white smoke when down shifting. also pops when down shifting is that normal? I guess it depends on a number of tings - how many miles has it done? Has it

Ad

Question about 1997 GSF 1200 Bandit S

1 Answer

there is a ticking in the top end of the engine and the bike has never had a valve adjustment could that be my problem? Absolutly.Especially if the noise reduces as the engine reaches operating ...

Ad

Question about 2005 GSF 1200 Bandit S

2 Answers

...amp;L petcock rebuild kit for $30 online. Manual valves are available for $20 if u care to turn it on and off every time you shut down. The needle seat has an o-ring that could be leaking as well as ...

Question about 2005 GSF 1200 Bandit S

1 Answer

My 98 1200 Bandit seem to have high current consumption. If I connect an ammeter inseries with the battery +ve lead and switch on ignition it reads 2.2 amps, this seems excessive. This is without the ...

...30 amp fuse on a 2002, 1200 S Suzuki bandit My 30 amp fuse keeps popping all wires look good. The bike will run for five minutes a pop fuse Have your voltage regulator checked a bad regulator will ...

...30 amp fuse for my starter solenoid kept blowing out every time I turned on my key. I put a new starter solenoid put to use. Wrote it for about three miles in a fuse popped again. I pulled the ...

Question about 1998 GSF 1200 Bandit S

1 Answer

On a 2000 Suzuki Bandit 1200S electrical problem Today the gas gage. neutral light, oil light, tach stopped working at the same time. Did something come unplugged? Where do i look first? Look for the ...

My 1997 suzukibandit1200 s. Ran fine. I shut it off for 5minutes,went to start and there was no power at all on the instrument panel. I checked the fuses and all were good. Any body no about this ...

i have bandit 1200 wont start in neutral with side stand down also no neutral light on dash. bike year 1999 please help This could be the clutch switch: 1. Check the wires to make sure they are ...

bike headlamp wireing problem headlamps getting very hot and keep blowing and when both connected up the high beam dash light goes out like they are drawing too much power. Have tried all ways i have ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...