Questions & Answers for: Ford F-150 300 10

...300 six cylinder. It is missing something on the drivers side inner fender. There are six plugs in the area of this missing part, two of them have single 10 gauge wire, one has two 10 ga. wires, one ...

300 inline 6. It will start and run but it runs rough and louder than before. (Like a diesel engine) I know that my gears are aligned with each other and I have not messed with the distributor. How do

...300 six 1978 f150 4x4,start the truck -starts good then stalls,start again it fires but stalls right away.does this about 10 to 20 times,then runs -get going and it will stall again.Once the motor is ...

300 inline 6 i need the torque specs for a 1987 ford 300 inline 6 cyl flywheel and pressure plate Tighten all bolts to 10 Lbs, then 20 Lbs, then 35 Lbs. That should be fine for the 6 cylinder flywheel

...300 6-cyl into my 91 bronco with a 351 V8 (5.8L) and used all the mounts and crossmembers off of the 94. only thing is the petal assm was different due to body changes. and the 5.8L also has a 11" ...

300 cu in engine HI!! 70-75 Foot pounds (Final torque) Torque sequence front of vehicle 11 7 3 2 6 10 14 13 9 5 1 4 8 12. Final torque must be reached in 3 equal steps Recheck final torque in sequence

300 straight 6 what are the stock timing specs and what is the stock air/fuel mixture for the 1 barrel carter cab The timing is 10 BTDC with the spout shorting par removed. The car is set to lean best

300 RPM. If it doesn't stall, it will go back and forth for about 2 min and slowly level out to an almost steady 700 or so. If I put it in gear during the hunting action, it runs fine and doesn't seem