...Motor malfunction C0B20 Finishing option Stapler Unit CDdrive failure C0B2S Finishing option Stapler Unit SlideMotor malfunction C0830 Finishing option Aligning Bar moving mechanism malfunction ...
...unit is used over 300,000 prints. Drum motor error DMOTRDYN signal does not go low within 2 s after DMOTONN signal goes low. The cause is; Defective harness between drum motor and engine PWB (YC11), ...
...developer unit Causes: Defective toner motor. Check procedures/corrective measures: Replace the developer unit Causes: Defective engine PWB. Check procedures/corrective measures: Replace the engine ...
...unit (polygon motor) error Call service 4200 laser scanner unit (pin photo sensor) error Call service 5100 short-circuited main charger output Call service 6000 broken fuser heater lamp M wire Call ...
...unit has got problem try to check its polygon motor whether its moving well LSU cleaning motor error When the LSU cleaning motor is driven, an error signal is detected continuously for 1 ...
call service 2830:0142588 how can i repair it myself? have you solved it ? we had a paper jam and the error is still active, tryed everything, nothin works :(
...motor. Pull the Developer Unit and then the drum unit out of the printer and check if the gears on both units are moving freely. Then turn the printer on without the 2 units and see if the motor is ...
...unit (see page 1-5-57). Developer motor MCY 1. To check the motor operation, execute DLP(MCY) by U030 (see page 1-3-34). 2. Check the drive gear can rotate or they are not unusually loaded and, ...
kyocera error code 2830 Error code 2830 displayed. Please specify the model
Question about Fs-3920dn Laser Printer
...motor. Excessive torque for driving drum unit or primary transfer unit. (Overloaded by a damaged gear.) Defective harness between engine controller PCB and main drive motor, or poor contact of the ...
Usually answered in minutes!
223 Questions
192 Questions
168 Questions
156 Questions
143 Questions