...GE washer broke down (discharge pump I think) and to get it fixed usually takes a couple of weeks. We thought it might be better to have a 2nd washing machine instead of paying the laundry mat. It ...
...GE washer delivered to my home today, June 24, 2008. All it will do is fill with water and than drain. The agitator cycle does not work and the spin cycle does not work. Model #WHDRR418G1WW, Serial # ...
GE should stick with building Jet engines and bulbs and not washers any more... This is a cronic and serious issue. Our washer and drier have been purchased in March of 2008, still under warranty. Dan
Question about Energy Star 3.7 IEC Cu. Ft. Front Load Washer with Stainless Steel Basket
...GE 3.7 Cu. Ft. Washer Front Loader - Model # WBVH6240FWW - 2008. Removed hose connecting to water pump at tub. Removed clog (ink pen, coins, etc). Replaced and ran washer. Ran through all cycles - no ...
Question about Energy Star 3.7 IEC Cu. Ft. Front Load Washer with Stainless Steel Basket
2008 GE Washer that won't spinor agitate. Belt is 2008 GE Washer that won't spinor agitate. Belt is fine, Drain pump is fine, I bypassed the lid switch by direct connecting 2 wires which didn't work. ...
...GE top load Profile washer. Spin cycle not working. Does not agitate either. Still fills and drains. 2008 model Hi, If you are having a problem with your top load washer then check out this tip... ...
GE washer model WHDSR316G2WW purchased in 2008. It was struck by lightning yesterday. The machine will fill with water and drain the water out, but will not adjitate or spin. The motor looks undamaged
...2008, It will run through a wash but want drain the water out, it just hums take off front cover (2) screws at bottom. drain pump is on lower right corner remove hoses (expect water - I use shop vac) ...
2008 GE PROFILE WASHER. THE WASHER WILL RUN WATER, BUT THE TUB WON'T SPIN OR WASH. You need to replace the "lid switch". Here is a link to the part you need. Here is a link to a video that may help ...
GE WASHER BELT TOP \DSR LOAD WHDSR316G1WW NEW BELT, CANNOT GET IT ON. TO TIGHT. WHDSR316G1WW 2008 HYDRO TOP LOAD WASHER. HOW CAN I GET BELT BACK ON put the belt on the motor pulley then start with the
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions