Questions & Answers for: 2003 passat abs light brake

...2003 Passat with a V/6 and now the brake light fault is on all the time. Is there a special procedure that I need to follow. it will need to get a scan tool on it to remove the light as the abs unit ...

passat/03/pd abs light/ and glow plug cumming on suspect one of the wheel sensors how do i iosolate the faulty one michael I have the same problem (along with traction light on). Both of my rear brake

2003 VW Passat Brake Failure I was backing out of a parking spot and my car **** and the ABS/ASR lights came on. Then I had not brakes. The petal was going to the floor and could not stop. I had to ...

passat 2001 lat model.... Error codes 1411 , 1423 and 1649 I would appraciate if you can describe the fault and what would needs to be done to fix it., Its a more than 5 year old car and has not given

...2003 Passat 1.8L turbo sedan. 2 months I have a 2003 Passat 1.8L turbo sedan. 2 months ago, I had the wheel bearing replaced on the right front. When I got the car back, I noticed when I make left ...

2003 passat ABS light on 2003 passat ABS light on perminantly Heater coil flashing no problems apparant is it to do with the cold weather? Check your brake lights. Well, 2 things, your car may have a ...

...ABS light came on solid. All the wiring looks good and even undisturbed by me. Any ideas? Reset abs by disconnecting negative ground at the battery for at least 30 seconds & reconnect . The light ...

...2003 vw passot,abs light and traction controll light is on, wife drove in snow with traction controll on, parked car next time drove car light was on, brakes ok, fluid full, I now fluid level should ...

passat TDI130 2003. It runs really well, but engine workshop lights up along with the esp, abs and the glow plug indicators lighting up, most garages are charging just for a diagnosis to the problem i

...2003 volkswagon Passat and when I drive 5 miles per hour the brake lights start blinking Sounds like a short in the ABS module. Need to replace it and or check the wiring to it. Not sure where the ...