Questions & Answers for: 2002 grand transmission fluid check

...2002 grand cherokee jeep, what kind of tranny fluid do I use? i have read not to use dexron or mercon 111,it says to use mopar atf 4. is my tranny fluid low and is that why it started slippin? thanks ...

...grand am 2002 how do you check/refill the transmission fluid on a 2002 grand am This a sealed for life unit,Still should service every 100,000 miles. It will need to be put on rack, there is a small ...

...2002 Pontiac Grand Prix sluggish when trying to accelerat when trying to accelerate my 2002 Pontiac Grand Prix it becomes sluggish even when i push the gas medal to the floor. It goes slow then picks ...

...2002 grand am about a month ago and i am having problems. when my car has to shift gears it takes a long time to shift. i will be going down the highway and i am stuck on 50 and it won't shift. then ...

...transmission fluid level is checked through a fill plug on the side of the transmission. THe fluid should be level with the bottom of the hole. Automatic transmission fluid is checked via a dipstick ...

...2002 Transmission Over-Temperature jeep 2002 TRANSMISSION OVER TEMPERATURE LIGHT--came on three times while driving under normal conditions---had Transmission and all fluids checked-- all fluids were ...

...2002 Jeep Grand Cherokee Laredo 4x4 Eratic shifting of gears at speeds of 55 to 75 I would check the transmission fluid level and color, should be a nice clear red color. You may need to have the ...

...2002 grand am GT) there are e few recommendations and descriptions that will help you understand. possibly go to pontiac site and download a diagram or location of inspection and fill locations No ...

...2002 Grand laredo have delay shifting gear have some delay before shifting gear Have you checked the trans fluid? Has to be checked with engine running in neutral. If its good you will need to bring ...

2002 grand am leaking transmission fluid from transmission sensor I think its a rubber o ring on the end of the sensor. check the o ring, but it could simply be the sensor needs tightening ,sometimes ...