Questions & Answers for: 2000 s10 blazer fuel pump

...s10 blazer I have a 1991 chevy s10 blazer 2door 4x4 that the fuel pump stopped working. I have replaced the fuel pump and it still will not start. I replaced the relay as well and still no luck. Can ...

...2000 S10 Blazer will only start when its cold if I use just the smallest amount of starting fluid. It will then run fine. Sometimes at average speeds I get a pulsation up and down. Sounds like fuel ...

...S10 Blazer Fuel Issues? Changed fuel pump, fuel pump relays, fuel filter, etc, and still cannot get my 1994 chevrolet s10 blazer to start. Cannot hear the sound the fuel pump makes when you turn the ...

...2000 chevy s10 blazer My driver side seat back is stuck in the forward position. engine wants to bog down when a/c is engaged, what is the problem to this? Fuel gauge and temperature gauge doesn't ...

2000 s10 blazer, tank is about half full of fuel. what is an easy and safe way to drain remaining fuel in tank? install new fuel pump 2000 s10 Purchase a syphon tube and a primer bulb. The primer bulb

2000 s10 blazer fuel gauge I recently replaced my fuel filter and since doing this my fuel gauge has been pegged above the full line. Any solutions??? check to verify you didn't bump or unplug wire ...

2000 chevy s10 blazer cranks but won't start???? Check for gas or spark problem on the engine. Check that starting fluid does start the car for a few seconds before dying, indicating a fuel delivery ...

S10 Blazer, we replaced the fuel pump, sending unit. The new pump and sending unit came with a new wiring plug. We made sure we wired it correctly. All the other gauges work, checked fuses. We are not

...2000 S10 blazer with one from 1985 S10 blazer? no, they are different pressure. it has to come from one with central fuel injection, like maybe 94 and up. also, the sending units even then 1999-2005: ...

s10 blazer fuel pump wont come on but if you take fuel pump relay off put jumper wire on the fuel pump will run then it will start The relay is grounded by the engine computer. The computer has to see