...Ford SVT Mustang Cobra and a rattling sound when driving the car already in idle temperature, each time the accelerator is pressed, I hear a rattling sound only while in gears and for a few seconds. ...
if my car heater doesn't throw out heat just cold air what can it be either thermostat needs repalcing or air trapped in heater. or blend door in plenum case not working. feel heater hoses going into ...
...2000 ford mustang and the heat is not working. cold air comes out when i turn the heat on. check to make sure the heater control valve is opening/ check to make sure that you have pressure in the ...
...2000 Ford Mustang GT and the AC and heat both work, but they only blow through the defrost and floor. Is this an expensive repair? It actually sounds very simple. There is a vacuum line that goes ...
No Heat The AC Compressor is running Replaced Thermostat but Still Ne Heat Could be a clogged heater core. Take off both hoses at heater core and flush out the core when done fillup core with fluid ...
Question about 2000 Mustang
...idle or in heavy traffic 2000 mustang When it starts to heat up the needle moves fast. Also if your able to start moving faster the needle will go back to normal fast. sounds to be a stuck ...
2000 mustang 3.8 run but when get hot its cut offf & want start until cool. I turn ignition on here harming noise on passenger side by fender, pull sparkplug wire off to see was firing was not, put ...
Question about 2000 Mustang
...2000 ford mustang coupe the heater valve door does open but we cant get the heat to work the a/c works grat and the heater coil is not cloged n theres a brand new thermastat in it as well if anyone ...
...mustang 2000 gt idles irradically and wants to die When you turn you heat or air on, your compressor engages. There could be a drag on your belt system. Listen to your air conditioning pump for ...
...2000 mustang? I have a 2000 mustang and under the dash on my brake light switch there is 2 wires connected to it, a red and black wire. Now why does my red wire keep burning in half? I have to strip ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions