...out of gear if I decerlerate when in 1st gear. It sometimes makes noise in 1st and it doesn's syncronize when downshifting into 1st. SYN. WORE DOWN check the oil in your gear box. it might be ...
...down in 1st. I have no clue as to what's causing this. Some advice. May be possible that clutch is disengaging when shifting to first and/or drive not fully switched into first gear. Your 1st gear ...
Question about X9350 All-In-One InkJet Printer
down 1st page of duplexing document is printed upside down (lexmark 9350 all in one ) make sure the driver is set to book bind duplex, rather than tablet style which is what it is doing now. Good Luck
down to 2nd where it starts from even is the 1st position??? dealer guy tells me I need major rebuild and torque converter, very skeptical of their opinion...codes pulled are 12 (out-put sensor and 25
...1st until rpm comes back down, shudders, clan, bangs and locks into 1st - shifts fine back up through the gears till OD. Changed filter and oil, added additive to free sticky solinoid - no use. It ...
Question about Imonitor Digital Baby Monitor
down on 1st parent unit. Keep holding it down. -Press on button on 1st parent unit and let go. -When you hear a beep, let go of negative volume button on 1st parent unit and then press it again. -When
Question about 1996 VN 1500 Vulcan Classic
...in 1st gear Shuts down once i let go of the clutch in 1st gear This is often a problem with the stand switch, unplug the cable and use a multi meter to make sure it switches when you move the ...
...1st gear. Take off in 3rd then down shift worked some times. most take offs in 2nd as it would not go to 1st. when it did go to 1st and shift to 2nd it was loud and could be felt. If it were an older ...
Question about 2004 Passat
I have trouble changing from 1st to 2nd gear and down from 2nd to 1st Difficult to change from 1st to 2nd gear transmission needs rebuilt
Question about 2003 Yukon Denali
My truck won't shift down into 1st gear automatically. I can select 1 and it engages 1st gear but will not shift down at all otherwise. it could be a sticking shift solenoid.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions