Questions & Answers for: 1997 ford f150 4 engine

1997 F-150's. The one recieving the motor has a full club cab on it, the other has a short extended cab on it. Both motors are the same size. We had problems putting the motor in because although they

1997 dodge ram. Hard starting when it is raining. I turn the key forward and let fuel pump kick in. Truck turns over no problem but you have to crank it over 4 - 5 times for about 10 seconds each time

ford pickup tranny. it will show you what it looks like and it is located in the tranny right between the tranny and engine. it is connected to the flywheel which is what your starter engages when you

...1997 F150,check engine light came on, took to mechanic, code P0443(evap system code)came up. Replaced evap purge solenoid, smoke injection test for leaks, everything seemed to be working correctly. I ...

...4) over the plug and begin to light tapping the freeze plug in the hole with , checking often for the direction and progress. To finish the plug setting in beyond the outside of the engine block, I ...

1997 f-150 4.6 L V8 I am throwing three engine codes. ( p0301, p0304,p0305) The truck is vibrating heavily and backfiring. I have replaced all the plugs, wires, and ignition coils and still have the ...

4 wheel drive system not operating, have already repaced drive motor on transfer case, still not working Lift and support the front of the truck so the front wheels are off the ground ( take safety ...

...1997 ford f150 heater will not blow hot air. i have replace the switch that controls the hot and cold air. i do not know what else to do. i do not heat any vacuum noise when i switch it to the heater ...

...Ford F150: Engine Misfire and Lean Code? http://whatisbyme.blogspot.in/2012/05/2004-ford-f150-engine-misfire-and-lean.html ----------- 1995 Toyota LS: Misfire at idle or low RPM ...

1997 Ford F-150 with manual transmission. Need of advice or help please. My transmission only shifts into second gear and no other gear. I'm only able to drive 30 mph in 2nd gear and have to rev up ...