...Dodge Spirit V6 (same car basically) behaved exactly the same as your LeBaron, to the extent that he was tired of being left stranded and no longer felt comfortable driving the car. The car was ...
...hall effect switch(pick up) has had the wires cut off and wired directly (not sure why). I tried the test listed in my haynes manual where you jumper two of the wires in the dist plug but still no ...
...it was built 9-90.It is a ram 150 with a 318 4x4. You got a crank sensor at back,on top of bellhousing. Injector pulse, I believe is controlled by hall effect sensor in distributor, as well as ...
...ignition coil and crank position sensor already.The ASD relay was replaced also.Do I replace the Hall Effect sensor? Is that assembly just below the distributor cap? Thanks for any help on
...hall effect sensor and how to change it? Take the distributor cap and rotor off! There are two screws,one on the back and one on the front of the distributor! Remove those and the hall effect pick up ...
...1991 dodge dakota 4x4 with 5.2 engine is in the shop & they can't figure out yet what is wrong. So far the plugs, tps, wires, cap, rotor & 2 reman computers were installed. They put in a new ...
...dodge spirit 11 No ignition reference signal detected during cranking (bad Hall effect) OR timing belt skipped one or more teeth; OR loss of either camshaft or crankshaft position sensor. Can cause ...
1991 dodge dakota 5.2 timing is there anything that needs unplugged when timing a 1991 dodge dakota 5.2. There is no timing to be done That is all done inside the computer on the inner right fender ...
Question about 1991 Spirit
...the coil, distributor cap, plugs, plug wires, hall-effect (coil pick up) sensor, ASD and have cleaned all contacts on the SBEC. What should I be checking or looking for? Crank sensor if she is a ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions