...1988 f150. I have not adjusted the ignition switch on the column. After proper adjustment will the shifter work properly? Is there any thing else to adjust? the first thing to check, is to make sure ...
Question about 1988 F 150
...1988 F150) and felt breakage inside the ignition key switch assembly. I removed the key and now I can not get the key back in to turn on. Currently the switch is in the on position, I have to ...
...1988 ford f150 will not start... the ignition system is fine, i have checked all of that. But my fuel pump is getting no power at all. Everything is brand new on it, i just bought all new pumps, ...
...1988 ford f150 will not start... the ignition system is fine, i have checked all of that. But my fuel pump is getting no power at all. Everything is brand new on it, i just bought all new pumps, ...
...f150 ican start with switch but as soon as i let go of switch it goes dead it wont run until you turn switch on to crank and as soon as you let go of switch it goes dead replace ignition switch this ...
f150? Hi there, First of all, make sure the ignition switch if off. Then you remove the ignition coil electrical connectors from each coil pack. Then you number or label each spark wire so you can put
...ford f150 5.8 engine eletrical diagram cut off interia switch wirers never twist the two wirers together which is pink with blk goes to the fuel pump and the brown goes power outout because the brown ...
1988 ford f150 starting problems Replaced solenoid....starter is fine ....alternator checked and good If the problem is the starter won't crank the engine over, check the small wire at the solenoid ...
Question about 1988 F 150
1988 f150 is shutting off randomly and getting worse.replaced ignition switch with no results. When it cuts off I can cycle the key and starts right up. Without cycling the key just turns over unless ...
Question about 1988 F 150
1988 F150 Ford van. Do I just drop colunm and pry plastic top half off? It is an intermittent problem and a mechanic suggested the switch replacement. Key cylinder works and the bar seems to be intact
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions