BRONCO IS NOT STARTING MIGHT HAVE ACTIVAte the fuel switch to turn off i need diagram how can i fix this. The Fuel Inertia Switch is Located At 1 of 2 Places 1 Under or at the passenger side Kick ...
...1988 ford bronco ii that will not run. we replaced one fuel switch already but someone told me that there was another one, but I can not find it. do you know where it is. We were thinking that it was ...
Question about 1988 Bronco II
...fuel pump on the frame of an 88 ford where does the wires from the fuel pump go to after they leave the fuel pump. the black wire is ground, the pink/blk goes to fuel pump and sending unit. if you ...
...1988 bronco 2 just stoped running. I checked the inertia switch , but it was not tripped. in tank fuel pump is getting old sounds like an ignition module. i had a simular problem where i would be ...
...fuel pump to show that it is ingaging last time i drove it it was fine. Check the inertia switch which is located on the passenger side under the carpet pull it out from the top toward the firewall ...
...side of the dash, above the brake pedal behind kick panel, there should be a hole to push reset button down. Just flip the switch back to ON position Bronco II opposite/passenger side in kick ...
...1988 bronco II v6 2.9 efi would start but will not idle now and smells like its flooding out? Only things i have done or changed is tested the fuel pump relay at the test center on pass fender and ...
Question about 1988 Bronco II
...bronco 2 is not getting power to the fuel pumps i changed the relay and the inertia switch stil no power Check the wires going to the fuel pump relay for a ground with the ignition on. The reay ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
