Questions & Answers for: Ford F-250 c 13 70

1970 Ford F250 converted into 4x4 I would like to convert a 1970 ford f250 into a 4x4 using the drive train from a 1979 ford f250 4x4. I was wondering if it is possible Its possible, myself i think it

45 ft.lbs. The flywheel to crank is 75-85 ft.lbs. The vibration damper is 70-90. The head bolts are 130-140. Hope this helps

Number 13 fuse with 30amp maxi in it blowed what While I was driving my 1995 f 305 ford 7.3 diesel died while driving it and found out that the number 13 fuse with 30amp maxi in it blowed what would ...

i have a f250 1995 when is 70 deg or lower dont start. 70 or high start and run perfect I would start by changeing the coolant temp. sensor for the emisions.This sensor controls the amount of fuel for

...start when cold, idles rough and dies. runs great once warmed up. Battery light is on but volts are 13.? Not sure if the 2 problems are connected or not It sounds like your preheat system is not ...

...brake line hanger to shock bracket back to factory location using M8 x 35MM bolt & spacer: 13 ft. lbs. Lower brake line bracket to lower spring bucket: 13 ft. lbs. Vacuum lines to sides of ...

...70 ft. lbs. (41-95 Nm) * Upper spring retainer: 13-18 ft. lbs. (18-24 Nm) ----------------------------------------------- Dana 60 Front Axle Observe the following torques; * Drive shaft-to-flange: ...

...HEAVY THROTTLE CONDITIONS - VEHICLES WITH 7.3L DI TURBO ENGINE AND TRANSMISSION BUILT PRIOR TO 11/13/95 (5L13) ^TRANSMISSION - E40D - DRIVELINERESONANCE/VIBRATION BETWEEN 1400 AND 2000 RPM WITH ...

trk will turn overbut want start no codes wa running fine ouit doing 70 pulled over will not crank It sounds like your altenator has gone bad and needs to be replaced.

1988ford f250 460 driving 70 down freeway truck dies turns over but wont start any ideas You need to do a fault code test follow the link. The connector is red and under the hood drivers side and ...